Tools; Items To Check After Assembly; Disassembly/Assembly Procedures - Epson AcuLaser C8500 Service Manual

EPSON AcuLaser C8500

3.1.2 Tools

The table below shows the tools used for servicing.
Table 3-1. Tools
Must
Phillips screw driver (#2)
Phillips screw driver (#1)
Tweezers
Pliers
Vol. 16 SELF TRAINING KIT
# 752 DIAGNOSTIC TOOL (Part Code: 1058540)

3.1.3 Items to Check after Assembly

Performs the items described below when completing assembly after repairing
the printer or replace any parts.
Clean the housings and the interior of the engine. See Section 6.1.2
"Description of the On-site Service".
After assembling or adjust the printer, print an engine status sheet to check
the counters for the consumables and other parts which need replacing. If
any of them is close to its life, replace it with a new one.
NOTE: After replacing the FUSER UNIT, one of the major after service parts,
perform the Fuser Counter Clear in the Maintenance mode. See
Section 6.2.1 "Entry to the Maintenance Menu".
NOTE: When replacing the MAIN FUSER ASSY, replace the FILTER ASSY
as well.
Check the program ROM version, and update it if necessary. Refer to
Section 3.2.3
Print several status sheets and check print quality.
Send a few pages of data from the host computer and check for proper
functions of the printer.
Disassembly/Assembly/Adjustment
Recommended
Soldering iron
E-ring holder
Mini screw driver

Disassembly/Assembly Procedures

3.2 Disassembly/Assembly Procedures
This section describes procedures for disassembling/assembling the printer.
Unless otherwise specified, assembly can be performed by reversing the
disassembly procedure. Refer to Section 3.3 for adjustment procedure. In
principle, you are to remove all options before servicing. However, you can
leave them if possible.
Some parts are listed as spare parts but not mentioned in
C A U T I O N
disassembly/assembly procedure. Therefore, look
carefully how they are installed before you removing them.
NOTE: Directions used in this section are defined as shown in the figure
below:
Left
Front
Figure 3-1. Directions
Revision C
Rear
Right
3-3