Rear Cover Removal - Epson StylusPro 10000 Service Manual

EPSON Stylus Pro 10000/10000CF
5. Opening I/C holder cover by pushing the central upper part (the cover latch location) of
it,then remove I/C holder cover with the hinge of the right and left.
6. Removing the E ring, then I/C holder cover and slowing-down gear are separated.
Slow-down gear
I/C Holder Cover
When installing the "I/C Holder Cover", make sure the position of
cover latch and cover interlock are placed correctly with frame.
Switch lever
Disassembly & assembly
E ring
Figure 4-21.
Figure 4-22.

4.2.1.7 Rear Cover Removal

1. From the rear, remove four white screws (CPS:M3x12) securing the optional interface
cover, and remove the optional interface cover.
Optional interface cover
Screw
2. Removing (CBS: 1 M3x6) the screw fixing HJFK (Dummy) board, then extract HJFK
(Dummy) board.
Screw
Disassembly Flow
Screw HJFK board / Dummy board
Figure 4-23.
HJFK board / Dummy board
Figure 4-24.
Revision A
126