Renesas M16C/6NK Hardware Manual page 400

16-bit single-chip microcomputer m16c family / m16c/60 series
Table of Contents

Advertisement

REVISION HISTORY
Rev.
Date
Page
2.00 Nov. 28, 2005
108
110
112
128
139
140
153
154
171
197
203
217
218
219
220
222
233
238
244
247
248
254
255
256
M16C/6N Group (M16C/6NK, M16C/6NM) Hardware Manual
12.1.3 Effect of Software Wait: 3rd to 9th lines is moved from next section of 12.1.2.
________
12.1.4 Effect of RDY Signal is added.
Table 12.2 DMA Transfer Cycles is revised.
Table 12.3 Coefficient j, k is revised.
12.5 Channel Priority and DMA Transfer Timing: Last sentence (Refer to ...) is added.
Figure 13.12 TA0MR to TA4MR Registers in PWM Mode: b2 is revised from "1" to "(blank)".
Figure 14.1 Three-Phase Motor Control Timer Function Block Diagram is revised.
Figure 14.2 INVC0 Register: NOTES 5 and 6 are revised.
Figure 15.5 U0BRG to U2BRG Registers (lower): NOTE 3 is added.
Figure 15.6 U0C0 to U2C0 Registers (lower): NOTE 5 is added.
Table 15.9 Example of Bit Rates and Settings: 20 MHz and NOTE 1 are added.
Figure 15.37 SiC Register (upper): NOTE 7 is added.
Figure 15.37 SiBRG Register (middle): NOTE 4 is added.
Figure 16.1 A/D Converter Block Diagram
• ADGSEL1 to ADGSEL0 (righit/lower) is revised from "10b" to "11b".
• NOTE 1 is added.
16.2.6 Output Impedance of Sensor under A/D Conversion
• 10th line: f(XIN) is revised to f(φAD).
Figure 16.10 Analog Input Pin and External Sensor Equivalent Circuit
• fAD is revised to φAD.
Figure 17.1 D/A Convertoer Block Diagram is revised.
Figure 17.2 DA0 and DA1 Registers: Setting Range is added.
Figure 17.3 D/A Converter Equivalent Circuit: NOTE 2 is added.
Figure 18.3 CRC Calculation is partly revised.
Figure 19.11 C0TECR, C1TECR Registers (2nd register): NOTE 1 is added.
Table 19.2 Examples of Bit-rate: NOTE 2 is added.
19.15.1 Reception: (5) is partly revised.
20. Programmable I/O Ports
• 8th line (Each pin functions ...) is partly revised.
• Last sentence (When using ...) is added.
• NOTE 1 is added.
20.1 PDi Register
• 4 th line: The sentence (During memory expansion ...) is added.
• NOTE 1 is added.
20.2 Pi Register
• 9 th line: The sentence (During memory expansion ...) is added.
• NOTE 1 is added.
20.3 PURj Register
• 5 th line: The sentence (However, the pull-up ...) is added.
• NOTE 1 is added.
Figure20.7 PDi Registers (upper): NOTE 2 is added.
Figure20.8 Pi Registers (upper): NOTE 2 is added.
Figure20.9 PUR0 Register (upper): NOTE 1 is added.
Figure20.9 PUR1 Register (middle): NOTES 1, 2 and 3 are added.
Description
Summary
C-4

Advertisement

Table of Contents
loading

This manual is also suitable for:

M16c/6nm

Table of Contents