Table of Contents
Advertisement
Under development
This document is under development and its contents are subject to change.
M16C/6N Group (M16C/6NK, M16C/6NM)
21.3.5.5 Block Erase Command
The block erase command erases each block.
By writing "xx20h" in the first bus cycle and "xxD0h" to the highest-order even address of a block in the
second bus cycle, an auto erase operation (erase and verify) will start in the specified block.
The FMR00 bit in the FMR0 register indicates whether an auto erase operation has been completed.
The FMR00 bit is set to "0" (busy) during auto erase and to "1" (ready) when the auto erase operation is
completed.
After the completion of an auto erase operation, the FMR07 bit in the FMR0 register indicates whether
or not the auto erase operation has been completed as expected. (Refer to 21.3.8 Full Status Check.)
Figure 21.9 shows a flow chart of the block erase command programming.
The lock bit protects each block from being programmed inadvertently. (Refer to 21.3.6 Data Protect
Function.)
In EW1 mode, do not execute this command on the block where the rewrite control program is allocated.
In EW0 mode, the microcomputer enters read status register mode as soon as an auto erase operation
starts. The status register can be read. The SR7 bit in the status register is set to "0" at the same time an
auto erase operation starts. It is set to "1" when an auto erase operation is completed. The microcomputer
remains in read status register mode until the read array command or read lock bit status command is
written. Also execute the clear status register command and block erase command at least 3 times until
an erase error is not generated when an erase error is generated.
NOTES:
1.Write the command code and data to even addresses.
2.Refer to Figure 21.12 Full Status Check and Handling Procedure for Each Error.
3.Execute the clear status register command and block erase command at least 3 times
Figure 21.9 Block Erase Command
Rev.2.00
Nov 28, 2005
REJ09B0124-0200
Write the command code "xx20h"
Write "xxD0h" to the highest-order
block address
Block erase operation is
completed
until an erase error is not generated when an erase error is generated.
page 275 of 378
Start
NO
FMR00=1?
YES
(2) (3)
Full status check
21. Flash Memory Version
Advertisement
Table of Contents
