Table of Contents
Advertisement
Chapter 9
9.5 Parts Replacement Procedure
9.5.1 Fixing Unit
9.5.1.1 Before Removing Fixing Unit
iR C3380i / iR C3380 / iR C2880i / iR C2880 / iR C3580 / iR C3580i / iR
C3080 / iR C3080i
1) Detach the rear right cover. (page 10-15)[Detaching the Rear Right
Cover]
2) Open the right cover fully (to the point where it does not interfere with oth-
er parts). (page 10-36)[Opening/Detaching the Right Cover]
9.5.1.2 Removing Fixing Unit
iR C3380i / iR C3380 / iR C2880i / iR C2880 / iR C3580 / iR C3580i / iR
C3080 / iR C3080i
1) Detach the connector cover [1].
- 1 screw [2]
2) Remove the fixing unit [1].
- 3 connectors [2]
- 4 screws [3]
[3]
F-9-10
9.5.2 Fixing Film Unit
9.5.2.1 Before Removing Fixing Film Unit
iR C3380i / iR C3380 / iR C2880i / iR C2880 / iR C3580 / iR C3580i / iR
C3080 / iR C3080i
1) Detach the rear right cover. (page 10-15)[Detaching the Rear Right
Cover]
2) Open the right cover fully (to the point where it does not interfere with oth-
er parts). (page 10-36)[Opening/Detaching the Right Cover]
3) Remove the fixing unit. (page 9-14)[Removing Fixing Unit]
9.5.2.2 Removing Fixing Film Unit
iR C3380i / iR C3380 / iR C2880i / iR C2880 / iR C3580 / iR C3580i / iR
C3080 / iR C3080i
1) Detach the fixing front cover [1].
- 2 screws [2]
9-14
[1]
[2]
F-9-9
[1]
[2]
[3]
[2]
0014-0573
2) Slide the shutter sensor holder [1] in the direction of the arrow to detach.
0014-0574
- 1 screw [2]
MEMO:
When detaching the shutter sensor holder, the 2 connectors [3] need not to
disconnect.
3) Remove the shutter unit [4].
- 5 screws [5]
[4]
[5]
[3]
[5]
[3]
Points to note when mounting the shutter unit
The fixing film may be damaged when the shutter unit [1] is mounted. Mount
it according to the following procedure.
1) Place the protective film [2] on the fixing film.
0013-8778
2) Fit the shutter unit [1] in the positioning area [2] and mount it.
0013-8779
[2]
[1]
F-9-11
[2]
[1]
F-9-12
[1]
[2]
F-9-13
[5]
Advertisement
Chapters
Table of Contents
