Pressure Roller; Removing The Pressure Roller; Fixing Film; Removing The Fixing Film Unit - Canon ImageRUNNER 1022iF Service Manual

[3] [1]
F-8-12
3) Remove the positioning pin.
4) Install positioning pin [2] to align with marking [1] at the front cover, and
then fix it with one screw [3]. When installing a new fixing unit, install
the positioning pin to align with reference mark [4].
[2] [3]
F-8-13
[2]
[4]
[1]
5) Perform the following procedure by reversing the installation procedure.

8.4.2 Pressure Roller

8.4.2.1 Removing the Pressure Roller

/ / / / iR1018 / iR1018J / / iR1022A / iR1022F / iR1022i / iR1022iF /
1) Remove the fixing film unit.
2) Remove the screw [1], and then slide the fixing unit inlet guide [2]
sideways to release it. (The fixing unit inlet guide need not be removed.)
3) Remove the pressure roller [3].
[3]
F-8-14
4) Release the hook and remove the gear [1]. The remaining part is the

pressure roller [2].

[2]
F-8-15
Precautions for Installation of Pressure Roller
When reinstalling the pressure roller, pay attention to the following:
1. The pressure roller bearing must be in touch with the leaf spring [1].
2. The left and right bearings [2] must be installed properly.
[1]
F-8-16

8.4.3 Fixing Film

8.4.3.1 Removing the Fixing Film Unit

/ / / / iR1018 / iR1018J / / iR1022A / iR1022F / iR1022i / iR1022iF /
1) Remove the fixing unit.
2) Remove the three screws [1], and then remove the reversing guide [2] and
sensor lever unit [3].
Chapter 8
0013-1242
[2]
[1]
[1]
[2]
0013-1239
8-7