Self-test mode of wired remote controller
Use of self-test mode
1 . When using the self-test mode of the wired remote controller, press the [＜] and [＞] buttons for more than 3 seconds .
2 . You can operate the self-test mode as follows .
f Load list: When pressing the corresponding button, you can set the load On or Off .
f When the water pump is turned off, the back up heater cannot be turned on .
f DHW valve, Zone #1 Valve, Zone #2 Valve and Mixing Valve cannot be turned on at the same time .
EHS MONO Kit-EU_IM_05388A-04_EN.indd 34
Zone #1 Valve
Back Up Heater 1
Back Up Heater 2
Back Up Boiler
Zone #2 Valve
2016-06-23 오후 3:43:08