YASKAWA FS100 Maintenance Manual page 69

159645-1CD
FS100
7 Operations After Replacing Parts
7.4 Setting the Second Home Position (Check Point)
• Perform the following inspection procedures prior to teaching the
manipulator. If problems are found, correct them immediately, and
be sure that all other necessary tasks have been performed.
– Check for problems in manipulator movement.
– Check for damage to the insulation and sheathing of external
wires.
• Return the programming pendant to a safe place after use.
If the programming pendant is inadvertently left on the manipulator,
on a fixture, or on the floor, the manipulator or a tool may collide with
the programming pendant during manipulator movement, which may
result in personal injury or equipment damage.
7-15
CAUTION
RE-CHO-A111
69 of 348