YASKAWA FS100 Maintenance Manual page 251

Alarm Alarm Name Sub
Number Code
4428 SEGMENT CONTROL 1
ERROR
2
3
4
5
8
9
10
4429 WRONG SPECIFIED 1
CONTROL GROUP
Meaning Cause
RT-buffer control command error Software operation error
occurred
Segment-receiving control Software operation error
command error occurred
No bank priority Software operation error
occurred
Answer error at MOVE simulating Software operation error
occurred
The value of bank_refresh_flag(x) Software operation error
exceeded its limit. occurred
RT-buffer tracking option error Software operation error
occurred
The segment was received Software operation error
although the previous segment occurred
had not been sent.
Segment creation is requested Software operation error
before segment-receiving is occurred
completed.
Control group not designated Software operation error
occurred
Remedy
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
251 of 348