YASKAWA FS100 Maintenance Manual page 261

Alarm Alarm Name Sub
Number Code
14
32770
32771
32772
32773
32774
32775
32776
32782
4447 DEFECTIVE TAUGHT
POINT(CIRC)
4449 UNMATCHED POSN
VAR DATA TYPE
4450 FILE NO. ERROR 1
2
Meaning Cause
The value for the character-string Setting error
type variable is less than the
minimum value.
The value for the signed 1-byte Setting error
data type variable exceeded the
maximum value.
The value for the unsigned 1-byte Setting error
data type variable exceeded the
maximum value.
The value for the signed 2-byte Setting error
data type variable exceeded the
maximum value.
The value for the unsigned 2-byte Setting error
data type variable exceeded the
maximum value.
The value for the signed 4-byte Setting error
data type variable exceeded the
maximum value.
The value for the unsigned 4-byte Setting error
data type variable exceeded the
maximum value.
The value for the real-number 4- Setting error
byte data type variable exceeded
the maximum value.
The value for the character-string Setting error
type variable exceeded the
maximum value.
Setting error
Setting error
An error occurred in tool file Setting error
number check.
An error occurred in user Setting error
coordinate file number check.
Remedy
(1)Check the following settings.
·Check the settings for variable, and then correct the job to fall within the input
range of the tag.
(1)Check the following settings.
·Check the settings for variable, and then correct the job to fall within the input
range of the tag.
(1)Check the following settings.
·Check the settings for variable, and then correct the job to fall within the input
range of the tag.
(1)Check the following settings.
·Check the settings for variable, and then correct the job to fall within the input
range of the tag.
(1)Check the following settings.
·Check the settings for variable, and then correct the job to fall within the input
range of the tag.
(1)Check the following settings.
·Check the settings for variable, and then correct the job to fall within the input
range of the tag.
(1)Check the following settings.
·Check the settings for variable, and then correct the job to fall within the input
range of the tag.
(1)Check the following settings.
·Check the settings for variable, and then correct the job to fall within the input
range of the tag.
(1)Check the following settings.
·Check the settings for variable, and then correct the job to fall within the input
range of the tag.
(1)Check the following settings.
·Check the settings for three teaching points so that circular interpolation steps
do not lie in a straight line.
(1)Check the following settings.
·Match the data type of position type variable.
(1)Check the following settings.
·Confirm that the specified tool file number is 0 to 63.
(1)Check the following settings.
·Confirm that the specified user coordinate file number is 1 to 63.
261 of 348