YASKAWA FS100 Maintenance Manual page 258

Alarm Alarm Name Sub
Number Code
3
4
5
6
7
4435 UNDEFINED LOCAL- 0
VARIABLE
1
2
3
4
5
6
7
Meaning Cause
The set data for real type variable Software operation error
area is incorrect. occurred
The set data for character-string Software operation error
type variable area is incorrect. occurred
The set data for robot-axis Software operation error
position-type variable area is occurred
incorrect.
The set data for base-axis Software operation error
position-type variable (S1D occurred
parameter) area is incorrect.
The set data for station-axis Software operation error
position-type variable (S1D occurred
parameter) area is incorrect.
The byte type variable is not Setting error
defined.
The integer type variable is not Setting error
defined.
The double-precision integer-type Setting error
variable is not defined.
The real-number type variable is Setting error
not defined.
The character-string type variable Setting error
is not defined.
The robot-axis position-type Setting error
variable is not defined.
The base-axis position-type Setting error
variable is not defined.
The station-axis position-type Setting error
variable is not defined.
Remedy
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Check the following settings.
·Set the number of local variables to be used in the job header.
(1)Check the following settings.
·Set the number of local variables to be used in the job header.
(1)Check the following settings.
·Set the number of local variables to be used in the job header.
(1)Check the following settings.
·Set the number of local variables to be used in the job header.
(1)Check the following settings.
·Set the number of local variables to be used in the job header.
(1)Check the following settings.
·Set the number of local variables to be used in the job header.
(1)Check the following settings.
·Set the number of local variables to be used in the job header.
(1)Check the following settings.
·Set the number of local variables to be used in the job header.
258 of 348