YASKAWA FS100 Maintenance Manual page 260

Alarm Alarm Name Sub
Number Code
5
255
4446 OVER VARIABLE LIMIT 0
1
2
3
4
5
6
7
8
Meaning Cause
A_BANK conversion has not been Software operation error
completed. occurred
An exceptional error occurred in Software operation error
job execution process. occurred
The variable value exceeded the Setting error
limit.
The value for the binary (0/1) data Setting error
type variable exceeded the limit.
The value for the signed 1-byte Setting error
data type variable is less than the
minimum value.
The value for the unsigned 1-byte Setting error
data type variable is less than the
minimum value.
The value for the signed 2-byte Setting error
data type variable is less than the
minimum value.
The value for the unsigned 2-byte Setting error
data type variable is less than the
minimum value.
The value for the signed 4-byte Setting error
data type variable is less than the
minimum value.
The value for the unsigned 4-byte Setting error
data type variable is less than the
minimum value.
The value for the real-number 4- Setting error
byte data type variable is less
than the minimum value.
Remedy
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Check the following settings.
·Check the settings for variable, and then correct the job to fall within the input
range of the tag.
(1)Check the following settings.
·Check the settings for variable, and then correct the job to fall within the input
range of the tag.
(1)Check the following settings.
·Check the settings for variable, and then correct the job to fall within the input
range of the tag.
(1)Check the following settings.
·Check the settings for variable, and then correct the job to fall within the input
range of the tag.
(1)Check the following settings.
·Check the settings for variable, and then correct the job to fall within the input
range of the tag.
(1)Check the following settings.
·Check the settings for variable, and then correct the job to fall within the input
range of the tag.
(1)Check the following settings.
·Check the settings for variable, and then correct the job to fall within the input
range of the tag.
(1)Check the following settings.
·Check the settings for variable, and then correct the job to fall within the input
range of the tag.
(1)Check the following settings.
·Check the settings for variable, and then correct the job to fall within the input
range of the tag.
260 of 348