YASKAWA FS100 Maintenance Manual page 285

Alarm Alarm Name Sub
Number Code
7
8
9
10
11
12
14
15
16
Meaning Cause
The layer motion function is not Software operation error
used. occurred
The general sensor function is not Software operation error
used. occurred
The servo float function is not Software operation error
used. occurred
The laser cutting function (with Software operation error
small circle cutter) is not used. occurred
The motor gun function (for spot Software operation error
welding application) is not used. occurred
The speed control function Software operation error
(VCON/VCOF) is not used. occurred
The laser cutting function (for Software operation error
form cutting operation) is not occurred
used.
The series communication Software operation error
function between the systems occurred
(PSEND/PRECV) is not used.
The motion extension function is Software operation error
not used. occurred
Remedy
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
285 of 348