YASKAWA FS100 Maintenance Manual page 292

Alarm Alarm Name Sub
Number Code
4605 SETTOOL ERROR 1
4606 LACK OF GLOBAL
VARIABLE AREA
4607 WRONG EXECUTION 1
OF MACRO INST
2
3
5
6
4608 WRONG EXECUTION 1
OF GETARG INST
2
3
4611 OVER OPTON INST
EXECUTION LIMIT
4612 TSYNC ERROR
Meaning Cause
The difference between the Setting error
current tool constant and a new
set value exceeded the allowable
range (parameter set value).
Software operation error
occurred
The execution macro job is not Setting error
set.
The interrupt macro job is not set. Setting error
An attempt was made to start the Setting error
job that could not be started by
the macro instruction.
An error occurred in the operation Software operation error
process of job call stack when the occurred
execution of macro instruction
was cancelled.
Incorrect macro number Software operation error
occurred
The job argument is not set. Setting error
No number of the specified job Setting error
argument
The data types of job argument Setting error
disagreed.
Setting error
Sub code: the number of Setting error
synchronizations of the first
executed TSYNC
Remedy
(1)Check the following settings.
·Correct the job so that the setting value of tag is allowable value.
·Set the allowance amount of the tool data automatic setting function maximum
deviation (S3C1192) to large value.
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Check the following settings.
·Check the settings for execution macro job.
(1)Check the following settings.
·Check the settings for interrupt macro job.
(1)Check the following settings.
·Check the settings for macro job.
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Check the following settings.
·Check the settings for jobs.
(1)Check the following settings.
·Check the settings for jobs.
(1)Check the following settings.
·Check the settings for jobs.
(1)Check the following settings.
·Check the settings for the OPTON instruction. OPTON instruction can use only
the function to five simultaneously.
(1)Check the following settings.
·Check the settings for the number of synchronizations of the TSYNC
instruction.
292 of 348