YASKAWA FS100 Maintenance Manual page 217

Alarm Alarm Name Sub
Number Code
234
235
236
237
238
239
240
241
244
Meaning Cause
Marking error for WORK ID Software operation error
conveyor queue (empty queue) occurred
Marking error for WORK IN/OUT Software operation error
conveyor queue (empty queue) occurred
Data error 1 at restarting after an Software operation error
emergency stop (actual status occurred
and the data status unmatched)
Data error 2 at restarting after an Software operation error
emergency stop (actual status occurred
and the data status unmatched)
Data error 3 at restarting after an Software operation error
emergency stop (actual status occurred
and the data status unmatched)
Timeout for receiving segment Software operation error
data output request occurred
The number which designates the Software operation error
setting area of correction amount occurred
in RT_BANK exceeded the limit
value.
Task error of the function calling Software operation error
source (cv_sync_intr ( )) occurred
GETTOOLW manipulator Software operation error
designation error occurred
Remedy
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
217 of 348