YASKAWA FS100 Maintenance Manual page 288

Alarm Alarm Name Sub
Number Code
4592 SPEED CTRL MODE
CANCEL ERROR(SV)
4595 CAN'T DO FIXED FORM 1
CUT MOTION
2
3
4
Meaning Cause
Software operation error
occurred
The setting for radius is incorrect. Setting error
(1) For a circle, it is incorrectly set
as: radius <= 0, or radius <
minimum radius value, or radius >
maximum radius value.
(2) For an ellipse, it is incorrectly
set as: radius <= 0 or radius <
minimum radius value/2, or radius
> (maximum radius/2 - width/2)
value.
The setting for width is incorrect. Setting error
(1) For a rectangle, it is incorrectly
set as: width < 1.0, width > sqrt
(maximum diameter2 - height2),
or width > maximum diameter.
(2) It is incorrectly set as: width <
0, width > maximum diameter -2 *
radius.
The setting for height is incorrect. Setting error
(1) For a rectangle, it is incorrectly
set as: height > maximum
diameter, height < minimum
diameter/2, or height > sqrt
2 2
(maximum diameter - width ).
The setting for the corner radius is Setting error
incorrect.
(1) For a rectangle, it is incorrectly
set as: corner radius > width/2 or
corner radius > height/2.
Remedy
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Check the following settings.
·Setting of the radius data
(1)Check the following settings.
·Setting of the width data
(1)Check the following settings.
·Setting of the height data
(1)Check the following settings.
·Setting of the corner radius
288 of 348