YASKAWA FS100 Maintenance Manual page 209

Alarm Alarm Name Sub
Number Code
59
61
62
63
64
66
67
68
69
Meaning Cause
AXIS servo OFF command Software operation error
execution system not set during occurred
category1 emergency stop
Conversion primary expression Software operation error
for Power Source command <-> occurred
EW command not prepared
Duplicated request error during Software operation error
master control-group tracking occurred
GVM shared resource semaphore Software operation error
error occurred
Job queue DEQUE error Software operation error
occurred
Execution system decision table Software operation error
not set occurred
Unknown mode data (Without Software operation error
TEACH/PLAY mode data) occurred
Shift-value output timeout of the Software operation error
general-purpose sensor occurred
Interrupt main status set Software operation error
occurred
Remedy
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
209 of 348