YASKAWA FS100 Maintenance Manual page 284

Alarm Alarm Name Sub
Number Code
2
4546 CANNOT EXCUTE
SYSTEM JOB
4547 PRIMITIVE ERROR
4548 CANNOT OPERATE
SPECIFIED EVENT
4549 NOT EXECUTION OF
INIEVNT
4550 CANNOT EXECUTE
INST (USER JOB)
4565 SOFTWARE UNMATCH 1
3
5
6
Meaning Cause
The extraction start position Setting error
exceeds the character string
length at MID$ instruction
execution.
Sub Code: System number Software operation error
occurred
Sub Code: Error code Software operation error
occurred
Sub Code: System number Software operation error
occurred
Sub Code: System number Setting error
Sub Code: System number Setting error
The multi-layer welding function is Software operation error
not used. occurred
The TURBO function is not used. Software operation error
occurred
The conveyor/press Software operation error
synchronization function is not occurred
used.
The shared motion function is not Software operation error
used. occurred
Remedy
(1)Check the following settings.
·Check the settings for the data of the character string to be extracted.
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Check the following settings.
·Execute an INIEVNT instruction before executing an event related instruction.
(1)Check the following settings.
·This instruction cannot be executed in the system job. Correct the job so that
the instruction is executed in the user job.
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
284 of 348