YASKAWA FS100 Maintenance Manual page 246

Alarm Alarm Name Sub
Number Code
29
30
31
32
33
38
39
41
45
Meaning Cause
Instruction prereading processing Software operation error
has not been completed normally. occurred
An error occurred in job data Software operation error
change. occurred
The specified sequence number Software operation error
at job execution start is incorrect. occurred
The added area for interruption Software operation error
command is incorrect. occurred
System number (MSS) for Software operation error
interruption command is incorrect. occurred
An error occurred at start of twin Software operation error
synchronous operation. occurred
An error occurred when SYNC Software operation error
specification was reset. occurred
An error occurred in occupation Software operation error
control group setting in MOTION occurred
section.
An error occurred in path/trace Software operation error
control. occurred
Remedy
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
246 of 348