YASKAWA FS100 Maintenance Manual page 151

Alarm Alarm Name Sub
Number Code
2
3
4
70
75
1221 ETHERNET INITIAL 1
PROCESS ERROR
2
3
Meaning Cause
Incorrect setting of the subnet Setting error
mask which is used in the
Ethernet function.
Incorrect setting of the default Setting error
gateway which is used in the
Ethernet function.
Incorrect setting of the host Setting error
address which is used in the
Ethernet function.
Incorrect setting of the host name Setting error
which is used in the Ethernet
function.
Incorrect setting of the domain Setting error
which is used in the Ethernet
function.
An error occurred in the device Software operation error
initialization process of the occurred
Ethernet function.
Main CPU board failure
An error occurred in the IP Setting error
address setting process of the
Ethernet function.
Software operation error
occurred
Main CPU board failure
An error occurred in the subnet Setting error
mask setting process of the
Ethernet function.
Software operation error
occurred
Remedy
(1)Check the following settings.
·Subnet mask of network in maintenance mode
(1)Check the following settings.
·Default gateway of network in maintenance mode
(1)Check the following settings.
·Server (host) of network in maintenance mode
(1)Check the following settings.
·Host name of network in maintenance mode
(1)Check the following settings.
·Domain name of network in maintenance mode
(1)Turn the power OFF then back ON.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Turn the power OFF then back ON.
(2)If the alarm occurs again, replace controller.
(1)Check the following settings.
·IP address setting of network in maintenance mode
(1)Turn the power OFF then back ON.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
(1)Turn the power OFF then back ON.
(2)If the alarm occurs again, replace controller.
(1)Check the following settings.
·Subnet mask of network in maintenance mode
(1)Turn the power OFF then back ON.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
151 of 348