Installing The New Lithostar Modularis Interface - Siemens SIREMOBIL Iso-C 3D Installation Instructions Manual

4 - 12

Installing the new LITHOSTAR MODULARIS interface

•
For easier accessibility, the SIREMOBIL Iso-C lifting column can be moved to the top
position. After this, disconnect the SIREMOBIL Iso-C from the power supply.
•
Remove the rear panel of the SIREMOBIL Iso-C basic unit.
•
Screw down the drilling template as shown in Fig. 25.
Fig. 25
•
To prevent drill shavings from melting into the surface, place a cloth or thin cardboard
over the cover (Fig. 25).
Inside:
•
With the 3.5 mm drill supplied, drill 3 holes using the holes of the template as a reference.
•
Remove the drilling template.
•
Using the step drill supplied, open the center hole to 28 mm.
•
To do this, drill open the hole until the step drill is immersed in the plate down to the mark
shown in Fig. 26 (approx. 0.5 mm from the largest drilled diameter of 30 mm).
•
Drill slowly! (approx. 300 to 500 rpm).
SIREMOBIL Iso-C 3D
Kapitelüberschrift hier eintragen
Fig. 26
SPR2-230.814.01
Rev. 05 08.04
Page 12 of 14
CS PS 24
4
Siemens AG
Medical Solutions