Debug Etherchannel - Cisco Catalyst 3650 Command Reference Manual

Layer 2/3 Commands

debug etherchannel

To enable debugging of EtherChannels, use the debug etherchannel command in privileged EXEC mode.
To disable debugging, use the no form of the command.
debug etherchannel [all | detail | error | event | idb ]
no debug etherchannel [all | detail | error | event | idb ]
Syntax Description
all
detail
error
event
idb
Command Default
Debugging is disabled.
Command Modes
Privileged EXEC
Command History
Release
Cisco IOS XE 3.3SE
Usage Guidelines
The undebug etherchannel command is the same as the no debug etherchannel command.
Note Although the linecard keyword is displayed in the command-line help, it is not supported.
When you enable debugging on a stack, it is enabled only on the active switch. To enable debugging on the
standby switch , start a session from the active switch by using the session switch-number command in
privileged EXEC mode. Enter the debug command at the command-line prompt of the standby switch.
To enable debugging on the standby switch without first starting a session on the active switch, use the remote
command switch-number LINE command in privileged EXEC mode.
Examples
This example shows how to display all EtherChannel debug messages:
Switch# debug etherchannel all
OL-32639-01
(Optional) Displays all EtherChannel debug messages.
(Optional) Displays detailed EtherChannel debug messages.
(Optional) Displays EtherChannel error debug messages.
(Optional) Displays EtherChannel event messages.
(Optional) Displays PAgP interface descriptor block debug messages.
Layer 2/3 Command Reference, Cisco IOS XE Release 3.6E (Catalyst 3650 Switch)

debug etherchannel

Modification
This command was introduced.
29