Toshiba e-STUDIO 2555C Service Manual page 1306

Sub
05/08 Mode Element
element
08 Setting Printer Finisher Batch read-in of
Mode adjustment value
08 Setting Printer Paper
mode feeding
08 Setting Printer Paper
mode feeding
08 Setting Printer Maintenan Waste toner box
mode ce
08 Setting Printer Maintenan Display of details of
mode ce CE80
Item Subitem Code
4696
4698
4699
4700
4706
Sub- Default Acceptable
Details
code value value
MJ-1036 -
Paper size (ISO-B5- 250/176 148-
R) feeding/widthwise 432/105-
direction 297
Paper size (KAKU2-R) 332/240 148-
feeding/widthwise 432/105-
direction 297
Detection setting of 3 0-6
nearly-full status
0 Y 0 0-15
69
RAM Contents
- M Copies and saves all the adjustment values of the
finisher to the equipment for the replacement of the
finisher control PC board due to damage.
* This code is not supported by LL20/25ppm model.
M
M
M Sets the value for judging nearly-full state after the
waste toner amount detection sensor detects waste
toner. Select the appropriate value if the detection error
occurs.
0: 0 (Judged as nearly-full state right after the detection
of the sensor)
1: 23670(30ppm), 22000(35ppm), 17000(45ppm),
14330(50ppm), 25670(25ppm)
2: 29580(30ppm), 27500(35ppm), 21250(45ppm),
17920(50ppm), 32080(25ppm)
3: 71000(30ppm), 66000(35ppm), 51000(45ppm),
43000(50ppm), 77000(25ppm)
4: 88750(30ppm), 82500(35ppm), 63750(45ppm),
53750(50ppm), 96250(25ppm)
5: 106500(30ppm), 99000(35ppm), 76500(45ppm),
64500(50ppm), 115500(25ppm)
6: Nearly-full detection is disabled
M Displays the details of CE80. Enter "0" to clear the
error.
0=Normal, 1=Error
bit0: Not connected
bit1: Mix
bit2: Checksum mismatch
bit3: Gradation module error
Proce Servic
dure e UI
3 Yes
10
10
1 Yes
4