Skew (Slantwise Copying) - Toshiba e-STUDIO281c Service Handbook

13)Skew (slantwise copying)

Cause/Section Step
Drawer/LCF 1
2
3
4
Paper feed roller 5
Rollers 6
Aligning amount 7
Registration 8
roller
Pre-registration 9
guide
2nd transfer 10
front guide
RADF 11
e-STUDIO281c/351c/451c
TROUBLESHOOTING
Check items
Is the drawer or LCF properly installed?
Is too much paper loaded in the drawer or
LCF?
Is the paper corner folded?
Are the drawer or LCF side guides prop-
erly set?
Is the surface of paper feed roller dirty?
Is each roller improperly fixed to the
shaft?
Is the aligning amount proper?
Is the registration roller spring removed?
Is the pre-registration guide improperly
installed?
Is the 2nd transfer front guide installed
properly?
Is the RADF installed and adjusted prop-
erly?
Fig. 5-13
Reinstall the drawer or LCF properly.
Reduce paper to 550 sheets or less.
(2500 sheets or less/stack for LCF)
Change the paper direction and reinsert it.
Adjust the side guides.
Clean the roller surface with alcohol, or
replace the roller.
Check and reinstall E-rings, pins, clips
and setscrews.
Increase the aligning amount.
Mount the spring correctly. Clean the
roller if it is dirty.
Correct it.
Correct it.
Reinstall and readjust it.
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
5 - 128
Measures