Quick Start Up; Quick Starting The Networking Device - Hirschmann PowerMICE Reference Manual

Quick Start up

2.0
The CLI Quick Start up details procedures to quickly become acquainted with the switch software.

2.1 Quick Starting the Networking Device

1. Read the device Installation Guide for the connectivity procedure. In-band connectivity allows
access to the switch software locally or from a remote workstation. The device must be configured
with IP information (IP address, subnet mask, and default gateway).
2. Turn the Power ON.
3. Allow the device to load the software until the login prompt appears. The device initial state is
called the default mode.
4. When the prompt asks for operator login, execute the following steps:
Quick Start up
© 2001- 2006 Hirschmann Automation and Control GmbH. All Rights Reserved.
Type the word admin in the login area. Since a number of the Quick Setup commands
require administrator account rights, Hirschmann suggests logging into an administrator
.
account
Enter the password private. There is the password private in the default mode.
Press the enter key two times.
The CLI User EXEC prompt will be displayed.
Use "enable" to networking device to the Privileged EXEC mode from User EXEC.
Use "configure" to switch to the Global Config mode from Privileged EXEC.
Use "exit" to return to the previous mode.
8