Quick Starting The Switch - Hirschmann RS20 Reference Manual

Quick Start up

2.1 Quick Starting the Switch

V Read the device Installation Guide for the connectivity procedure. In-band
connectivity allows access to the Hirschmann software locally or from a
remote workstation. The device must be configured with IP information (IP
address, subnet mask, and default gateway).
V Turn the Power ON.
V Allow the device to load the software until the login prompt appears. The
device initial state is called the default mode.
V When the prompt asks for operator login, execute the following steps:
D
Type the word admin in the login area. Since a number of the Quick
Setup commands require administrator account rights, CLI suggests
logging into an administrator account. Enter the state on delivery pass-
word private.
D
Press the enter key.
D
The CLI User EXEC prompt ((Hirschmann PowerMICE) >) will be
displayed.
D
Use "enable" to switch to the Privileged EXEC mode from User EXEC
(Privileged EXEC prompt: (Hirschmann PowerMICE) #).
D
Use "configure" to switch to the Global Config mode from Privileged
EXEC
(Global Config prompt: (Hirschmann PowerMICE) (Config)#).
D
Use "exit" to return to the previous mode.
22
2.1 Quick Starting the Switch
CLI L2B
Release 4.0 11/07