Installing The Sfp Modules; Adjusting The Dip Switch Settings On The Basic Module (4-Pin Dip Switch) - Hirschmann MICE MS20-0800 Series User Manual

2.1.4

Installing the SFP modules

 To attach an SFP module, first remove the protective cap over the socket.
 Push the SFP module with the lock closed into the socket until it latches
audibly in place.
Note: Only use Hirschmann SFP modules.
Figure 13: Installing an SFP module
2.1.5 Adjusting the DIP switch settings on the basic
module (4-pin DIP switch)
The 4-pin DIP switch on the bottom panel of the basic module gives you the
following options:
DIP switch Function
RM (redundancy When the HIPER-Ring function is
a
manager) switched on, you can switch the RM
(Redundancy Manager) function on and
off (see "User Manual - Redundancy
Configuration").
b
Ring port Selecting the ports for the HIPER-Ring
MS30: In the ON position, ports 1 and 2 in
module 2 form the connection for the
HIPER-Ring.
MS20: In the ON position, port 1 from
modules 1 and 2 form the connection for
the HIPER-Ring.
a
Stand-by With the redundant coupling of rings, you
assign the redundancy function to the
MICE in the redundant line (see "User
Manual - Redundancy Configuration").
SW Configuration / OFF: Give the software configuration
DIP Configuration precedence over of the DIP switch
position. In this case, the other switch
positions are meaningless.
a. You can use the "RM" and "Stand-by" switches on the 4-pin DIP switch to switch the
following functions on and off
b. The "Ringport" switch on the 4-pin DIP switch enables you to select the ring ports for the
HIPER-Ring (see table 6)
MS20/MS30 MS20/MS30
Release 10 07/2012
(see table 7)
State on delivery
OFF position (RM function
deactivated)
OFF position (ports 1 and 2
in module 1 form the
connection for the HIPER-
Ring).
OFF position (normal
function)
OFF position (SW
configuration has
precedence)
37