Honda C8R600F4 Service Manual page 286

HYDRAULIC BRAKE
REAR BRAKE PAD REPLACEMENT
Always replace the Push the caliper piston all the way in to allow instal-
brake pads in
lation of new brake pads.
pairs to ensure
even disc pressure.
NOTE:
Check the brake fluid level in the brake reservoir a::>
this operation causes the level to rise.
Remove the pad pin plug and loosen the pad pin.
Remove the rear brake caliper bolt.
Pivot the caliper up, and remove the pad pin and
brake pads.
Be careful not to Install new brake pads so that their ends are
lose the pad spring.
positioned on the retainer on the caliper bracket as
shown