Honda C8R600F4 Service Manual page 41

FRAME/BODY PANELS/EXHAUST SYSTEM
FRONT FAIRING
Remove the socket bolts and the rearview mirrors.
Rt:m1uve the trim clip from the instrument panel.
Remove the six screws and two nuts.
Remove the instrument panels.
Release the air vent hose (California: No. 8) from
the hose clip and disconnect it from the 3-way hose
joint.
Be careful not to
Remove the two trim clips and six socket bolts.
scratch the front
Remove the front fairing off the rearview mirror
fairing and fender.
bolt hole studs and rest it on the front fender.
Disconnect the headlight and turn signal connec-
tors.
Installation is in the reverse order of removal.
NOTE:
•Install the front fairing air duct grill over the air
intake ducts and the bosses into the fairing stay
grommets and align the front fairing tabs with
the inner fairing slits.
•When tightening the fairing socket bolts, be
careful not to dislodge the rubber nuts in the side
fairing.
•When installing the instrument panel, align the
groove with the tab of the duct cover.
TORQUE:
Fairing socket bolt:
2 N·m (0.2 kgf·m, 1.4 lbf·ft)
CONNECTORS
GROMMETS
TRIM CLIPS
AIR DUCT GRILL
MIRRORS
SCREW AND NUT
INSTRUMENT PANEL
SLITS
2-5