Honda C8R600F4 Service Manual page 192

AL TERNA TOR/ST ARTER CLUTCH
ALTERNATOR STATOR
10-2
LEFT CRANKCASE COVER REMOVAL
Remove the left side fairing (page 2-4).
Disconnect the alternator 3P (White) connector.
Remove the left crankcase cover bolts and the left
crankcase cover.
CAUTION:
The left crankcase cover (stator) is magnetically
attached to the flywheel, be careful during removal.
NOTE:
The engine oil will run out when the left crankcase
cover is removed. Set a clean oil pan under the en-
gine and add the recommended oil to the specified
level after installation.
Remove the gasket and dowel pin.
ST ATOR REPLACEMENT
Remove the clamp bolt and clamp.
Remove the four bolts, grommet and stator from
the left crankcase cover.
Install a new stator onto the left crankcase cover.
Apply sealant to the grommet seating surface and
install it into the cover groove properly.
Set the wire properly and install the wire clamp
with the bolt.
TORQUE: 14 N·m (1.4 kgf.m, 10 lbf.ft)
Install and tighten the stator bolts.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
LEFT CRANKCASE COVER
INSTALLATION
Apply sealant to the crankcase mating surfaces as
shown.
10-15 mm
(0.4-0.6 in)