FUEL SYSTEM
Romovo tho throttle atop oorcw from the holder.
Loosen the four carburetor insulator band screws
at the engine side, using a long screwdriver
through the hole in both sides of the frame.
Place a clean shop
Remove the carburetor assembly off the cylinder
towel over the
head intake ports.
intake ports to
prevent any
Disconnect the throttle sensor connector.
foreir:;n material
from dropping into
NOTE:
the engine.
5-16
Do not remove the throttle sensor unless it is
necessary to replace it or disassemQle the caruure-
tor. For sensor inspection and replacement, see
page 17-7.
Loosen the throttle cable lock nuts, then
remove
the cables from the cable holder and disconnect
them from the throttle drum.
Disconnect the water tubes from the carburetor.