Honda C8R600F4 Service Manual page 209

CRANKCASE ASSEMBLY
Apply sealant to the crankcase mating surfaces as
shown.
Install the three dowel pins and the two oil orifices
by aligning the flat surfaces.
Apply molybdenum oil solution to the main journal
bearing surfaces on the lower crankcase.
Install the lower crankcase onto the upper crank-
case, aligning the shift forks with the gear shifter
grooves.
Apply engine oil to the 8 mm bolt threads and seat-
ing surfaces.
Install the 10 mm bolt, ten 8 mm bolts and eight
6 mm bolts and tighten them in a crisscross pattern
in 2 or 3 steps.
TORQUE: 10 mm bolt: 39 N·m (4.0 kgf·m, 29 I bf.ft)
8 mm bolt: 25 N·m (2.6 kgf·m, 19 lbf.ft)
Install the sealing
Install the five 8 mm bolts and seven 6 mm bolts
washers indicated
with new sealing washers.
by the"
c. "
Tighten the bolts in a crisscross pattern in 2 or 3
marks. steps.
TORQUE: 8 mm bolt: 25 N·m (2.5 kgf·m, 18 lbf·ft)
CRANKCASE/TRANSMISSION
11-11