Honda C8R600F4 Service Manual page 350

LIGHTS/METERS/SWITCHES
REMOVAL/INSTALLATION
Disconnect the side stand switch 2P (green) connec-
tor.
Remove the side stand switch bolt and the switch.
Install the side stand switch by aligning the switch
pin with the side stand hole and the switch groove
with the bracket pin.
Install the side stand switch bolt and tighten it.
TORQUE: 10 N·m (1.0 kgf.m, 7 lbf.ft)
Install the removed parts in the reverse order.
NOTE:
Route the side stand switch wire properly (page
1-18).
LOW FUEL INDICATOR/FUEL RESERVE
SENSOR
19-16
INSPECTION
Raise the fuel tank (page 2-3).
Low fuel indicator does not go off
Disconnect the Brown/black wire connector from
the fuel reserve sensor.
Turn the ignition switch ON and check the low fuel
indicator.
• If the indicator does not come on, replace the fuel
reserve sensor.
•If the indicator comes on, check for short circuit
in Brown/black wire.
Low fuel indicator does not come on
Check that the speedometer, tachometer and cool-
ant temperature gauge function properly.
• If they do not function, perform the power/
ground line inspeGtiu11 of Lhe GurntJination meter
(page 19-7).
• If they function, disconnect the fuel reserve sen-
sor connectors and short the connector terminals
with a jumper wire.
Turn the ignition switch ON arid check the low
fuel indicator.
- If the indicator comes on, replace the fuel reserve
sensor.
-If the indicator does not come on, check for an
open circuit in Brown/black and Green/black
wires.
If they are OK, replace the printed circuit board
(page 19-7).
SWITCH PIN---
VE SENSOR.:1:fr
NNECTOjiS
d