Evaporative Emission Control System (California Type Only) - Honda C8R600F4 Service Manual

Check the reed for damage or fatigue. Replace if
necessary.
Replace the PAIR check valve if the seat rubber is
cracked, deteriorated or damaged, or if there is
clearance between the reed and :;eat.
lnsta.11 the PAIR check valves and cover onto the cyl-
inder head cover.
Install the cover bolts and tighten them.
TORQUE: 13 N·m (1.3 kgf·m, 9 lbf.ft)
Install the radiator (page 3-7).
PAIR CONTROL VALVE REMOVAL/
INSTALLATION
Remove the radiator without disconnecting the
water hoses (page 3-6).
Disconnect ttie air :;uµµly hu::;es and vacuum tube
to remove the PAIR control valve.
Installation is in the reverse order of removal.
EVAPORATIVE EMISSION CONTROL
SYSTEM (California type only)
NOTE:
Refer to the Vacuum Hose Routing Diagram Label
and Cable & Harness Routing (page 1-18) for the
tube connections and routing.
EVAPORATIVE EMISSION (EVAP)
CANISTER REMOVAL/INSTALLATION
Disconnect the No. 1, No. 4 and No. 2 tubes from
the EVAP canister.
Remove the 6 mm mountino holt
Remove the side fairing socket bolt and fairing stay,
and the EVAP canister with the bracket.
Remove the two bolts, collars and bracket.
Install the EVAP canister in the reverse order of
removal.
FUEL SYSTEM
REED STOPPER
5-39