Honda C8R600F4 Service Manual page 76

LUBRICATION SYSTEM
Apply sealant to the oil pressure switch threads as
shown and install it.
TORQUE: 12 N-m (1.2 kgf.m, 9 !bf.ft)
CAUTION:
To preve11t cri:111ki;i:1:;e di:1111i:1ye, clu nut uvertiyhte11
the switch.
Connect the oil pressure switch wire and tighten
the terminal screw.
TORQUE : 2 N-m (0.2 kgf·m , 1.4 lbf.ft)
Install the rubber cap properly.
Install the fuel tank (page 2-3).
Start the engine.
Check that the oil pressure indicator goes out after
one or two seconds.
If the oil pressure indicator stays on, stop the
engine and check the indicator system (page 19-12).
OIL STRAINER/PRESSURE RELIEF VALVE
OIL PAN REMOVAL
4-4
Drain tilt: tmgine oil (page 3-12).
Remove the exhaust pipe (page 2-7).
Remove the reserve tank breather tube from the
stay.
Remove the eleven bolts and the oil pan.
OIL STRAINER
Remove the oil strainer and seal rubber from the oil
pump.
Clean the oil strainer screen thoroughly.
Coat a new seal rubber with oil and install it onto
the strainer.
Install the oil strainer by aligning its tab with the
groove in the crankcase.
Do not apply to the thread head.
\ \ 3- 4 mm (0.1-0.2 in)
...
,
.....