Honda C8R600F4 Service Manual page 111

Tighten the each connecting nuts gradually and
alternately, be sure the bolt threads projections are
equal height (within 0-3 mm).
Hold the nut and tighten the nut on other side.
TORQUE: 6
mm nut: 9 N.m (0.9 kgf.m , 6.5 !bf.ft)
5
mm nut: 5 N·m (0.5 kgf.m , 3.6 !bf.ft)
Install the arm return spring over the boss on the SE vAM ARM
No. 2 carburetor.
Install the plastic collars onto the SE valve arm
bosses of the carburetors.
Install the SE valve arm over the SE valves and
onto the carburetors and attach the return spring.
Install the plastic washers and screws and tighten
them.
Install the throttle stop screw with the washer and
spring.
Turn the throttle stop screw to align the throttle
valve with the edge of the outside by-pass hole in
the No. 4 carburetor.
Align each carburetor (No. 1, No. 2 and No. 3)
throttle valve with the outside by-pass hole by
turning the synchronization adjusting screw.
Rotate the throttle drum and be sure that each
throttle valve opens and closes smoothly.
COLLARS
FUEL SYSTEM
0-3mm
~REWS
AND WASHERS
SPRING
5-29