ALTERNATOR/STARTER CLUTCH
Install the starter driven gear while turning 1t coun-
terclockwise.
Make sure that the starter driven gear turns counter-
clockwise smoothly and does not turn clockwise.
Install the flywheel (see below).
FLYWHEEL INSTALLATION
10-6
Apply oil to the needle bearing.
Clean any oil from the tapered portion of the crank-
shaft and flywheel.
Install the woodruff key in the crankshaft key
groove.
Install the flywheel aligning the kev way in the fly-
wheel with the woodruff key on the crankshaft.
Apply engine oil to the flywheel bolt threads and
seating surface.
Install the special washer and flywheel bolt.
Hold the flywheel with the special tool and tighten
the bolt.
TOOL:
Flywheel holder
07725-0040000 or
equivalent commercially
available in U.S.A.
TORQUE: 103 N·m (10.5 kgf·m, 76 lbf·ft)