Honda C8R600F4 Service Manual page 109

NOTE:
•Always replace the 0-rings with new ones and
coat them with oil.
•Apply grease
to
the synchronization adjusting
screw tips.
No. 3 and No. 4 carburetors:
Install the following onto the carburetor:
-dowel pins
water tube joint with new 0-rings
air vent hose joint with new 0-rings
-fuel tube joint with new 0-rings
- joint collar
-choke cable holder, aligning groove with stopper
-thrust spring (place over the synchronization nut)
Assemble the No. 3 and No. 4 carburetors.
Install the synchronization spring.
No. 1 and No. 2 carburetors:
Install the following onto the carburetor:
-dowel pins
-water tube joint with new 0-rings
-air vent hose joint with new 0-rings
-fuel tube joint with new 0-rings
-joint collar
-thrust spring (place over the synchronization nut)
Assemble the No. 1 and No. 2 carburetors.
Install the synchronization spring.
No. 1/2 and No. 3/4 carburetors:
Install the dowel pins onto the carburetor.
Assemble the No. 1/2 and No. 3/4 carburetors.
Install the synchronization spring.
FUEL SYSTEM
5-27