Brake/Taillight - Honda C8R600F4 Service Manual

LIGHTS/METERS/SWITCHES
While pushing the bulb in, turn it counterclockwise
to remove it, and replace it with a new one.
Make sure that the lens gasket is installed in posi-
tion and is in good condition, and replace it with
new one
if
necessary.
Install the lens, aligning the slot with the tab of the
turn signal light, and tighten the screw.
REMOVAL/INSTALLATION
Front: Remove the instrument panels (page
2-b).
Rear: Remove the seat (page 2-2).
Disconnect the turn signal light connectors.
Remove the nut, setting plate and the turn signal
light.
Install the turn signal light in the reverse order of re-
moval.
NOTE:
Route the turn signal light wire properly (page 1-18).
BRAKE/TAILLIGHT
BULB REPLACEMENT
Remove the seat (page 2-2).
Turn the socket counterclockwise and remove it
from the brake/taillight.
Ht:AK I UKN ::ilGNAL LIGH I
SETTING PLATE NUT