Honda C8R600F4 Service Manual page 40

FRAME/BODY PANELS/EXHAUST SYSTEM
SIDE FAIRING
Remove the following:
-three trim clips
-two screws
- six socket bolts.
Release the boss from the duct cover grommet and
remove the side cowl.
Left side fairing
Remove the fuel tank drain and breather tubes.
only:
Installation is in the rever:se
urder of removal.
NOTE:
Be careful not to dislodge the rubber nuts in the
side fairing when tightening the front side bolts.
TORQUE: Socket bolt (Three bolts on front side):
2 N·m (0.2 kgf·m, 1.4 lbf·ft)
FRONT INNER FAIRING
2-4
Remove the following:
-four trim clips
-four screws
- inner fairing by releasing front fairing tabs from
inner fairing slits.
Installation is in the reverse order of removal.
NOTE:
Make sure that the mating areas are aligned proper-
ly before tightening the fasteners.
TORQUE: Screw: 2 N·m (0.2 kgf·m , 1.4 lbf.ft)
Short
SIDE FAIRING
TABS
TRIM CLIPS
GROMMET
SCREWS
TRIM CLIPS