Cooling Fan Motor Switch - Honda C8R600F4 Service Manual

COOLING FAN MOTOR SWITCH
Remove the left side fairing (page 2-4).
INSPECTION
Fan motor does not stop
Turn the ignition switch OFF, disconnect the
connector from the fan motor switch and turn the
ignition switch ON again.
• If the fan motor does not stop, check for short cir-
cuit between the fan motor and switch.
• If the fan motor stops, replace the fan motor
switch.
Fan motor does not start
Before testing, check for a blown fan motor fuse.
Wrirm up the engine to operating temperature.
Disconnect the connector from the fan motor
switch and ground the connector with a jumper
wire.
Turn the ignition switch ON and check the fan mo-
tor.
• If the motor starts, check the connection at the
fan motor switch terminal. If it is OK, replace the
fan motor switch.
•If the fon motor docs not start, measure the
voltage between the Black/blue ( +) and Green
(-)wire terminals at the fan motor 2P connector.
There should be battery voltage.
If there is battery voltage, replace the fan motor.
-If there is no voltage, check for open circuit in
Black/blue rinrl Grnen wirns_
REMOVAL/INSTALLATION
Drain the coolant (page 6-5).
Disconnect the fan motor switch connector and re-
move the switch.
Install a new 0-ring
~nto
the fan motor switr.h_
Install and tighten the fan motor switch.
TORQUE: 18 N·m (1.8 kgf·m, 13 lbf·ft)
Connect the fan motor switch connector.
Fill and bleed the cooling system (page 6-4).
LIGHTS/METERS/SWITCHES
19-11