Honda C8R600F4 Service Manual page 106

FUEL SYSTEM
5-24
CAUTION:
Handle the jets with care. They can easily be
sr.nr~d
nr
sr.ratr.h~d.
Hang the float valve onto the float arm lip.
Install the float valve, float and fluat µin.
FLOAT LEVEL INSPECTION
NOTE:
Set the float level gauge that it is perpendicular to
the float chamber face at the highest point of the
float.
With the float valve seated and the float arm just
touching the valve, measure the float level with the
float level gauge.
TOOL:
Float level gauge
07 401-0010000
FIOAT 1.FVFL·
n
7
+
0 !i mm (0 54 t 0.02 in)
The float cannot be adjusted.
Replace the float assembly if the float level is out of
specification.
Install a new 0-ring into the float chamber groove.
Install the float chamber and tighten the three
screws.
VACUUM CHAMBER
Coat a new 0-ring with oil and install it into the
holder groove, and the spring into the holder end
hole.
Install the washer onto the jet needle.
Install the jet needle and needle holder into the vac-
uum piston.
Press the needle holder until you feel a click
indicating that the 0-ring is seated into the groove
in the vacuum piston.
D.IAPHRAGM/PISTON
~
---:711 /
s •
Iii
0-RING