Honda C8R600F4 Service Manual page 234

FRONT WHEEL/SUSPENSION/STEERING
Install the handlebar weight onto the inner weight,
aligning the bosses and grooves each other.
Install a new weight mounting screw and tighten it
while holding the weight.
TORQUE: 10 N·m (1.0 kgf·m, 7 !bf.ft)
Connect the choke cable to the choke lever.
Install the
le~
handlebar switch housing onto the
handlebar, aligning its locating pin with the hole in
the handlebar.
Tighten the forward screw first, then the rear screw.
Install the clutch lever bracket and bracket holder
with the "UP" mark facing up.
Align the end of the clutch lever bracket with the
punch mark on the handlebar, and tighten the
upper bolt first, then the lower bolt.
Connect the clutch switch connectors.
FRONT WHEEL
REMOVAL
13 ..
s
Support the motorcycle securely using a hoist or
equivalent and raise the front wheel off the ground.
Remove
Lt1e
four bolt::; and the front fender.
Remove the mounting bolts and front brake cali-
pers.
CAUTION:
Support the brake caliper so that it does not hang
from the brake hose. Do not twist the brake hose.
NOTE:
Do not operate the brake lever after removing the
brake calipers.