Honda C8R600F4 Service Manual page 44

FRAME/BODY PANELS/EXHAUST SYSTEM
REAR FENDER/SEAT RAIL
REMOVAL
Remove the seat cowl (page 2-2).
Remove the battery (page 16-4).
Disconnect the following:
-turn signal and license light connectors (release
the clamp).
-seat lock cable from seat catch on cross member
Remove the following:
-fuel cut-off relay
-turn signal relay
-fuel pump transfer relay
-air vent control solenoid valve relay
(49
state/
Canada only)
-fuse box by releasing the tab on reverse side of
fender
-rear shock absorber reservoir by loosing band
screw
-starter relay switch
Remove the fender mounting nuts, washers and
bolts.
Slide the rear fender rearward, then remove the
mounting collars (between the seat rail and fender)
and remove the fender from the seat rail.
Remove the fuel tank (page 2-3).
Remove the following:
-wire harness bands
-ignition control module (ICM)
bolts and regulator/rectifier
- bolts, collars and fuel pump
Secure the reservoir so that it remains upright.
Remove the nuts, bolts, washer and the passenger
footpeg brackets.
· Remove the four mounting nuts, bolts and seat rail.
INSTALLATION
Route the wire
Installation is in the reverse order of removal.
harnesses, cable
and hose properly
TORQUE:
(page 1-18). Seat rail mounting: 49
N·rn (5.0 kgf.m, 36 !bf.ft)
Footpeg bracket:
26 N·rn (2.7 kgf-m, 20 !bf.ft)
2-8
CONNECTORS
SEAT LOCK CABLE
\_
RELAYS
FUSE BOX
RESERVOIR
REGULATOR/RECTIFIER
BAND