Install the cover bolts.
Do not pinch the
Connect the ignition pulse generator 2P connector.
ignition pulse
generator wire
Connect the clutch cable to the lifter arm and install
between the water
the cable holder with the bolt.
hose and engine.
Tighten the four cover bolts first in a numerical or-
der on the crankcase cover in 2 or 3 steps.
TORQUE: 12 N·m (1.2 kgf.m, 9 lbf·ft)
Tighten the other cover bolts to the same torque.
Fill the crankcase with recommended engine oil
{page
3-12).
Adjust the clutch cable (page 3-23).
Install the side fairing (page 2-4).
CLUTCH/GEARSHIFT LINKAGE
9-15