Honda C8R600F4 Service Manual page 145

Install the engine into the frame and swingarm.
Carefully align the
Install the following:
hanger bolt holes
-center hanger bolt (8)
in the frame and
-front hanger bolts
(A)
and
(0)
with spacers
engine.
1. Tighten the center hanger bolt (8).
TORQUE :
39
N·m
(4.0
kgf.m, 29
I
bf.ft)
2. Tighten the front hanger bolt (A/.
TORQUE :
39 N.m (4.0 kgf.m , 29 I bf.ft)
3. Tighten the front hanger bolt (0).
TORQUE : 39 N·m (4.0 kgf-m, 29 !bf.ft)
4.
Install the center adjusting bolt
(E)
until it just
contacts to the engine. Tighten the adjusting bolt
(E)
to the specified torque, then turn it out 180°.
TORQUE : 4
N·m
(0.4
kgf·m, 2.9 !bf.ft)
5.
Install the lock nut
(E).
Hold the adjusting bolt
(E)
and tighten the lock nut
(E).
TOOL:
Lock nut wrench 07VMA-M 880100
TORQUE : Acutual:
54
N·m
(5.5
kgf.m,
40
lbf·ft)
Indicated:
49
N·m
(5.0
kgf·m ,
36
!bf.ft)
6.
Set the right spacer
(F)
between the frame and
engine (Temporarily install the rear hanger bolt
(C)
to align the spacer). Install
the
adjusting bolt
(F)
until it just contacts to the spacer.
Remove the hanger bolt
(C)
and tighten the rear
adjusting bolt
(F)
to the specified torque, then
turn it out 180°.
TORQUE : 4 N m (0.4 kgf m , 2.9 lbf ft)
7.
Install the lock nut
(F).
Hold the adjusting bolt
(F)
and tighten the lock nut
(F).
TOOL:
Lock nut wrench 07VMA-M B BO 100
TORQUE : Acutual: 54 N·m (5.5 kgf·m , 40 lbf·ft)
Indicated: 49
N·m
(5.0
kgf.m,
36
lbf.ft)
6. l11slall the ce11t1:1r hange1 bolt {E) and tigl 1len
it.
TORQUE : 39
N·m (4.0 kgf.m, 29 lbf·ft)
9. Install the rear hanger bolt (C) from the left side
with the left spacer.
Install the rear hanger nut (F) and tighten it.
TORQUE: 39 N·m (4.0 kgf·m, 29 I bf.ft)
10. Install the swingarm pivot bolt (page 14-17).
ENGINE REMOVAL/INSTALLATION
Right side:
7-7