Honda C8R600F4 Service Manual page 219

Install the dowel pins and oil orifices.
Carefully install the lower crankcase on the upper
crankcase.
Apply engine oil to the main journal 8 mm bolt
threads and seating surfaces and install them.
Tighten the bolts in a crisscross pattern in 2 or 3
steps.
TORQUE :
25
N·m
(2.6
kgf.m,
19
I bf.ft)
Remove the lower crankcase and measure the
compressed plastigauge at its widest point on each
main journal to determine the oil clearance.
SERVICE LIMIT:
0.05 mm (0.002 in)
If the oil clearance exceeds the service limit, select
the correct replacement bearings.
BEARING SELECTION
Record the crankcase bearing support 1.0. code let-
ters.
NOTE:
Letters (A, 8 or Cl on the left side of upper crank-
case are the codes tor the bearing support 1.0. s
from left to right.
Record the corresponding main journal O.D. code
numbers.
NOTE:
Numbers (1, 2 or 3) on the crank weight are the
codes for the main journal O.D. s from IGft to right.
CRANKSHAFT /PISTON/CYLINDER
12-7