Honda C8R600F4 Service Manual page 232

FRONT WHEEL/SUSPENSION/STEERING
13 .. 4
Install the handlebar omo the fork, aligning its boss
with the groove in the fork top bridge.
Install the stopper ring and tighten the handlebar
pinch bolt.
Install the right handlebar switch/throttle housing
onto the handlebar, aligning its locating pin with
the hole in the handlebar.
Tighten the forward screw first, then the rear screw.
Install the front brake master cylinder and holder
with the "UP" mark facing up.
Align the end of the master cylinder with the punch
mark on the handlebar, and tighten the upper bolt
first, then the lower bolt.
TORQUE: 12 N·m (1.2 kgf.m, 9 lbf·ft)
Connect the front brake light switch connectors.
Install the handlebar weight onto the inner weight,
aligning the bosses and grooves each other.
Install a new weight mounting screw and tighten it
while holding the weight.
TORQUE: 10 N·m (1.0 kgf.m, 7 !bf.ft)
Check the throttle grip operation and free play
(page 3-4).