Honda C8R600F4 Service Manual page 172

CYLINDER HEAD/VALVE
Install the head cover onto the cylinder head.
Install the special washers onto the head cover
holts with thA "UP" mark facing the halt hAad.
Install the three head cover bolts by aligning them
with the bolt hole in the cylinder head properly.
Tighten the bolts in 2 or 3 steps.
TORQUE: 10 N·m (1.0 kgf.m, 7 lbf·ft)
Connect the air suppiy hoses and the vacuum tube
to install the PAIR control valve.
Install the direct ignition coils onto the spark plugs.
The cylinder
Connect each 2P connector to the correct ignition
numbers are
coil.
printed on each
ignition coil wire.
Install the carburetor (page 5-30).
8-22
Fill and bleed the cooling system if the cylinder
head was removed (page 6-4).