Honda C8R600F4 Service Manual page 140

ENGINE REMOVAL/INSTALLATION
SERVICE INFORMATION
GENERAL
•A hoist or equivalent is required to support the motorcycle when removing and installing the engine.
•A floor jack or other adjustable support is required to support and maneuver the engine.
CAUTION:
Do
not
use the oil filter
as a
jacking point.
•When using the lock nut wrench for the adjusting bolt lock nut, use a deflecting beam type torque wrench 20 inches long.
The lock nut wrench increases the torque wrench's leverage, so the torque wrench reading will be less than the torque
actually applied to the lock nut. The specification given is the actual torque applied to the lock nut, not the reading on the
torque wrench. Do not overtighten the lock nut. The specification later in the text gives both actual and indicated.
•The following components require engine removal for service:
-transmission (section 11)
·-crankshaft/piston/cylinder (section 12)
•When installing the engine, be sure to tighten the engine mounting fasteners to the specified torque in the specified
sequence. If you mistake the tightening torque or sequence, loosen all mounting fasteners, then tighten them again to the
specified torque in the correct sequence.
SPECIFICATIONS
TORQUE VALUES
Front engine hanger bolt
Center engine hanger bolt
Ctmlt::r 1::1r19in1::1 tiang1::1r adju:;tirr9 !Joll (rigtil :;id1::1)
Center engine hanger lock nut (right side)
Rear engine hanger nut
Rear engine hanger adjusting bolt (right side)
Rear engine hanger lock nut (right side)
Shock link bracket nut
Shock link-to-bracket nut
Drive sprocket bolt
Starter motor terminal nut
Oil pressure switch terminal screw
TOOL
Lock nut wrench
7-?
39 N-m (4.0 kgf.m , 29 lbf·ft)
39 N·m (4.0 kgf.m, 29 lbf·ft)
4
N·m
(0.4 kgf·rn , 2.9 lbf·ft)
54 N·m (5.5 kgf·m, 40 lbf·ft)
39 N·m (4.0 kgf.m, 29 !bf.ft)
4 N·m (0.4 kgf·m, 2.9 !bf.ft)
54 N·m (5.5 kgf.m, 40 lbf·ft)
39 N·m (4.0 kgf.m, 29 lbf·ft)
44 N·m (4.5 kgf·m, 33 !bf.ft)
54 N·m (5.5 kgf·m, 40 lbf·ft)
10 N·m (1.0 kgf·m, 7 !bf.ft)
2 N·m (0.2 kgf.m , 1.4 lbf.ft)
07VMA-MBB0100